Friday, December 03, 2010

NEW ANSI REQUIREMENT – TILE INDUSTRY

It is official. The floor flatness requirements in ANSI 108.1 are now 1/8” in 10’ for any tile with an edge of 15” or greater. There is a public comment period on this before it is published, but there shouldn’t be any problem. This tighter requirement helps tile contractors avoid excessive floor preparation and the associated back charges.

OK, so what does this mean ..?  To the architect / designer ...?  To the Owner ..?  To the GC / Builder ...?  To the Tile Sub-Contractor / Installer ..?

Labels:

1 Comments:

Anonymous signature tile said...

Nice. Now to start passing this information on to the builders designers and architects out there.

December 4, 2010 at 3:46 PM  

Post a Comment

<< Home